Clarke 3108005 운영 및 유지보수 지침 매뉴얼 - 페이지 11

{카테고리_이름} Clarke 3108005에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3108005 17 페이지. 3pc air tool kit

MAINTENANCE

SPRAY GUN MAINTENANCE

It is essential that the spray gun is kept clean. Dried paint in the nozzle

assembly or airways will stop the gun from working. For the gun to perform at

its best it must be thoroughly cleaned after every use.

CLEANING PROCEDURE

1. After use, empty any remaining paint from the paint container, wipe the

container clean with a dry, lint free rag, and fill with thinner. Spray the

thinners through the spray gun until it is clean.

2. Residue from dirty solvent may clog the narrow air passages in the gun. Use

a small cleaning brush and solvent to wash off accumulated paint.

3. Wipe down the outside of the gun with a solvent dampened cloth.

• DO NOT poke any of the holes in the nozzle with metal instruments.

These holes are precision drilled and can be damaged by probing

with anything harder than a wooden toothpick.

4. Make sure that the air inlet vent to the paint container is kept clean.

Blockages in this vent will prevent an even material flow through the gun.

• Component parts of spray guns are supplied in matched sets and

should only be used together.

• Do not overtighten components, and be careful not to cross thread

any parts on assembly.

• Never use silicon based lubricants which may cause paint finish

defects.

5. Check the air supply hose regularly for any signs of damage and replace it

if necessary. Do not use damaged or leaking hoses.

6. Finally, empty the spray gun and dry all components thoroughly. Store in a

clean, dry place.

REPLACEMENT PARTS

When replacing parts, only use those supplied by Clarke International as

stated in the parts list on page 15.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]