Clarke 3108005 운영 및 유지보수 지침 매뉴얼 - 페이지 9
{카테고리_이름} Clarke 3108005에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3108005 17 페이지. 3pc air tool kit
페이지 인쇄
• Moving quickly over the surface will give a thin coat and slow
movement will give a heavy coat.
• Apply one coat at a time. If a further coat is required, make sure you
observe the manufacturers drying time recommendations before
applying a second coat.
• When spraying small areas, keep the output control on a low setting
as this will avoid using too much paint and prevent overspray.
10. Where possible, avoid stopping and starting when spraying. This can lead
to too much, or not enough paint being applied .
• The material deposited should always be even and wet. Lap each
stroke over the preceding stroke to obtain a uniform finish.
• To ensure the edges are covered, start spraying just to the side of the
area being sprayed and do not stop until the spray has gone past
the opposite edge.
• Damage to the needle or nozzle, or any of the air ports, will result in a
faulty spray pattern. Take care when cleaning or assembling these
components.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9