Clarke 3108005 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke 3108005에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3108005 17 페이지. 3pc air tool kit

4. To reduce overspray, always use the lowest possible air pressure that

produces an acceptable spray pattern.

• If the gun is too far from the surface or the paint is too thin, the paint

will start to dry before hitting the surface, resulting in a rough, sandy

finish. Allowing overspray to fall on a finished area will also result in a

rough finish. Too much paint feed or holding the gun too close to the

work will lead to runs and sagging.

• The paint should be agitated by gentle shaking at regular intervals

during use to ensure consistency and avoid colour difference due to

the paint settling in the container.

5. To obtain the best results, keep

your spray gun level and parallel

to the surface at all times. Keep

the nozzle 23 - 30 cm from the

surface and spray evenly from

side to side or up and down. Use

your arm to control the spray gun,

not your wrist.

6. The gun should be perpendicular

to the surface being covered and

moved parallel with it. The stroke

should be started before the trigger is pulled and likewise released before

the stroke is ended. This gives accurate control of the gun and material.

7. Do not spray at an angle as this

will lead to paint runs on the

surface. Always use a smooth and

even stroke.

8. When spraying large areas, use a

criss-cross pattern as shown.

9. Never start or stop the spray gun

while it is aimed at the surface to

be sprayed. Evenly control the

speed of movement of the spray

gun.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]