Clarke 3108005 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke 3108005에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3108005 17 페이지. 3pc air tool kit

3. Remember that some modern paints require specialist respiratory

protection. Always consult the paint manufacturers instructions.

WARNING: NEVER ATTEMPT TO SPRAY UNLESS YOU ARE WEARING

SUITABLE, APPROVED RESPIRATORY AND EYE PROTECTION.

4. Ensure that the area in which you will be spraying is clean and dust free. To

obtain best results, it is vital that the surface to be sprayed is well prepared.

It must be clean, free from dust, dirt and grease. Mask any area that is not

to be sprayed and cover adjacent equipment to protect from overspray.

5. Check the paint manufacturers instructions for any special surface

preparation required.

• REMEMBER - TIME SPENT PREPARING SAVES TIME SPENT FINISHING.

PAINT THINNING

Paint thinning is particularly important when spraying. Many paints are

supplied ready for brush application and need to be sufficiently diluted for

spraying purposes. Always follow the paint manufacturers instructions. If in

doubt, always consult the paint manufacturer.

A Viscosity Cup (not supplied), will assist in determining the correct thickness of

the paint.

The ideal viscosity for most paints is as follows:

Water based paints

Oil based paints

Enamel paints

Primers

Varnishes

Aluminium paints

Wood preservatives

Wood Stains

Smooth masonry paint

1. Dip the cup into the paint and fill to the brim. Time how long it takes for the

cup to empty.

2. Thin as required until times are achieved.

3. Alternatively if a viscosity cup is not available, the following information

can be used as a rough guide.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

35-45 secs

15-25 secs

20-30 secs

20-25 secs

15-25 secs

Do not dilute

Dilute by 10-15%