Clarke 3108005 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke 3108005에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3108005 17 페이지. 3pc air tool kit

SPRAY GUN OPERATION & USE

CAUTION: THE ITEMS IN THIS KIT HAVE A LOWER WORKING PRESSURE

THAN MANY COMPRESSORS WILL SUPPLY, THEREFORE, AN AIRLINE

REGULATOR SHOULD BE INSTALLED. SEE PAGE 4 FOR WORKING

PRESSURES.

CAUTION: AIRLINE LUBRICATORS SHOULD NOT BE USED WITH THESE ITEMS

This professional type gravity fed

spray gun is suitable for use with most

conventional paints. The spray gun is

fed with paint from the paint

container. The airflow through the air

cap draws paint into the nozzle

assembly, where it is atomised and

sprayed forward.

1. Operate this spray gun from an air

compressor capable of delivering

8 cfm.

2. Follow all safety precautions when attaching the spray gun to the air hose.

PREPARATION BEFORE PAINTING

1. Mix the paint to the correct viscosity for spraying according to the paint

manufacturers instructions and strain it into the paint container through a

fine mesh filter. When mixing the paint, make sure that you have enough

thinners left to clean the spray gun after use.

2. Do not fill the paint container to

more than 3/4 full. Make sure that

the top edge of the container

and lid are clean and free from

damage before mounting the

gun on the container. It is also very

important to keep the container

vent clear.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]