Clarke CFC100 운영 및 유지 관리 지침 - 페이지 5

{카테고리_이름} Clarke CFC100에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CFC100 6 페이지. Folding crane
Clarke CFC100에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (13 페이지)

페이지 인쇄

PARTS DIAGRAM

ASSEMBLY

NOTE:

During assembly, unless otherwise stated, nuts and bolts should be finger

tight only. They should be fully tightened, once assembly is completed, in

the manner described below.

All figures in brackets, refer to the parts list item numbers.

Attach the two castors to the Base using the bolts supplied, tighten the

bolts securely.

Insert the Left Hand Leg (3) into its housing in the base, line up the holes

and insert the pin (12), securing in place with the 'R' clip (13). Repeat the

procedure for the Right Hand Leg (4).

NOTE:

The leg ends should be parallel when legs are correctly assembled.

Attach the Main Column (1) to the base using the five nuts, bolts and

washers provided.

With assistance, lift the Ram assembly and enter the lower mounting into

its housing on the main support. Locate it using the Bolt (17), and secure

the bolt with washer (16) and nut (28). Rest the ram against the main

column.

With assistance, raise the jib (5) and slide it into position on top of the

main column, locate it using the bolt (15), and secure the bolt with washer

(16) and nut (28).

Lower the jib and position the ram so that its upper end slides into the housing

on the jib. Line up the holes and locate it using the bolt (21), secure the bolt

with washer (16) and nut (28).

NOTE:

It may be necessary to extend the ram slightly in order for the holes to line up. See

'Operation' for details of how to achieve this.

Insert the jib extension (6) into the end of the jib and secure in one of the

four positions using the Lock Pin and 'R' Clip (71).

Attach the hook and chain assembly (24) to the end of the jib extension

using bolt (23) secure with washer (68) and nut (25). Tighten securely.

Bolt the Handle (14) onto the main column using the four bolts (20) with

washers (19) and tighten securely.

10.

Rock the assembly to ensure that no part is under stress, then tighten all

nuts and bolts, ensuring they are completely secure.

11.

To fold the legs, for storage purposes, first manoeuvre the crane to its storage

location, then lower the stabilising foot and secure with bolt (10) and nut

(11).

12.

Remove the 'R' clips from the leg locking pins then remove the locking

pins. Lift each leg to the vertical position, securing in place, again using the

locking pins. Replace the 'R' clips.