Clarke CONTRACTOR 6462119 운영 및 유지보수 지침 매뉴얼 - 페이지 18

{카테고리_이름} Clarke CONTRACTOR 6462119에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR 6462119 20 페이지. Worktop jig

19. Fully insert 3 pins in the holes marked 'CB'.

20. Clamp the jig to the worktop ensuring all 3 pins are pushed firmly against the

worktop. Ensure clamps do not obstruct the router path.

21. Place the router into the front of one of the clamp bolt recesses, set the depth of

cut to 10mm max. Switch the router ON and machine the recess. When done,

switch the router OFF and wait for the cutter to stop spinning. Return the router to

the back again. Increase the depth of cut a further 10mm and machine the recess

again. When finished, switch the router OFF and wait for it to stop spinning.

22. Repeat step 21 for the other 2 recesses (other 3 recesses for 900mm worktops).

Recesses must be no deeper than 20mm maximum.

Shaping Corners

Cutting

- Position the router (guide bush) on the edge of the jig at the post form end,

ensure the router base is flush on the jig surface. Set the cut depth to 10mm max.

3. Switch the router ON and slowly move the router following the edge of the jig.

Switch OFF and wait for the cutter to stop spinning.

4. Lift the router off the jig and return it to the start position again, increase the depth

of cut a further 10mm and make a second pass. Keep repeating steps 3 & 4 until

the cut is complete, i.e. the cutter is below the bottom of the worktop.

9. Switch the router OFF and wait for it to stop spinning, remove the router and jig,

store them away safely for reuse.

Post Form Edge

-17-

IMPORTANT

- Position jig on worktop as in Fig. 24 below.

Cut Direction

Fig. 24

15mm