Clarke KIT1100 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke KIT1100에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke KIT1100 17 페이지. Air tool kit

The ideal viscosity for most paints is as follows:

Water based paints

Oil based paints

Enamel paints

Primers

Varnishes

Aluminium paints

Wood preservatives

Wood Stains

Smooth masonry paint

1. Dip the cup into the paint and fill to the brim. Time how long it takes for the

cup to empty.

2. Thin as required until times are achieved.

3. Alternatively if a viscosity cup is not available, the following information

can be used as a rough guide.

• Water based paints (emulsions) 10-20% water.

• Oil based paints (gloss) up to 10% thinners.

• Cellulose paints up to 50% cellulose thinners.

4. If in any doubt, contact the paint manufacturer.

5. Having mixed the paint thoroughly in a separate container, pour into the

spray gun paint container through a fine filter.

• DO NOT OVERFILL PAINT CONTAINER - never more than three

quarters full.

• To avoid creating a vacuum, remove the vent cap from the top of

the paint container before spraying. Replace the cap to avoid

spillage when you stop.

ADJUSTMENTS OF THE SPRAY GUN

ADJUSTING THE PAINT SPRAY PATTERN

1. Set the Spray Adjustment knob (1) according to the paint in use and the

spray pattern required to give either a wide, fan shaped spray pattern or a

narrow spray pattern.

2. You can adjust the orientation of the fan pattern either vertically or

horizontally to suit your requirements by turning the nozzle side wings (2) to

the desired position.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

35-45 secs

15-25 secs

20-30 secs

20-25 secs

15-25 secs

Do not dilute

Dilute by 10-15%