Clarke KIT1100 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke KIT1100에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke KIT1100 17 페이지. Air tool kit

PREPARATION BEFORE PAINTING

1. Mix the paint to the correct viscosity for spraying according to the paint

manufacturer's instructions and strain it into the paint container through a

fine mesh filter. When mixing the paint, make sure that you have enough

thinners left to clean the spray gun after use.

2. Do not fill the paint container to

more than 3/4 full. Make sure that

the top edge of the container

and lid are clean and free from

damage before mounting the

gun on the container. It is also very

important to keep the container

vent clear.

3. Remember that some modern

paints require specialist respiratory

protection. Always consult the

paint manufacturers instructions.

WARNING: NEVER ATTEMPT TO SPRAY UNLESS YOU ARE WEARING

SUITABLE, APPROVED RESPIRATORY AND EYE PROTECTION.

4. Ensure that the area in which you will be spraying is clean and dust free. To

obtain best results, it is vital that the surface to be sprayed is well prepared.

It must be clean, free from dust, dirt and grease. Mask any area that is not

to be sprayed and cover adjacent equipment to protect from overspray.

5. Ensure the surface to be painted is clean, dry and free from oil or dust.

Check the paint manufacturer's instructions for any special surface

preparation required.

REMEMBER - TIME SPENT PREPARING SAVES TIME SPENT FINISHING.

PAINT THINNING

Paint thinning is particularly important when spraying. Many paints are

supplied ready for brush application and need to be sufficiently diluted for

spraying purposes. Always follow the paint manufacturers instructions. If in

doubt, always consult the paint manufacturer.

A Viscosity Cup (not supplied), will assist in determining the correct thickness of

the paint.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]