Clarke KIT1100 Manuel d'utilisation et d'entretien - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke KIT1100. Clarke KIT1100 17 pages. Air tool kit
Imprimer la page
PREPARATION BEFORE PAINTING
1. Mix the paint to the correct viscosity for spraying according to the paint
manufacturer's instructions and strain it into the paint container through a
fine mesh filter. When mixing the paint, make sure that you have enough
thinners left to clean the spray gun after use.
2. Do not fill the paint container to
more than 3/4 full. Make sure that
the top edge of the container
and lid are clean and free from
damage before mounting the
gun on the container. It is also very
important to keep the container
vent clear.
3. Remember that some modern
paints require specialist respiratory
protection. Always consult the
paint manufacturers instructions.
WARNING: NEVER ATTEMPT TO SPRAY UNLESS YOU ARE WEARING
SUITABLE, APPROVED RESPIRATORY AND EYE PROTECTION.
4. Ensure that the area in which you will be spraying is clean and dust free. To
obtain best results, it is vital that the surface to be sprayed is well prepared.
It must be clean, free from dust, dirt and grease. Mask any area that is not
to be sprayed and cover adjacent equipment to protect from overspray.
5. Ensure the surface to be painted is clean, dry and free from oil or dust.
Check the paint manufacturer's instructions for any special surface
preparation required.
REMEMBER - TIME SPENT PREPARING SAVES TIME SPENT FINISHING.
PAINT THINNING
Paint thinning is particularly important when spraying. Many paints are
supplied ready for brush application and need to be sufficiently diluted for
spraying purposes. Always follow the paint manufacturers instructions. If in
doubt, always consult the paint manufacturer.
A Viscosity Cup (not supplied), will assist in determining the correct thickness of
the paint.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7