Clarus Technologies PCS-25 운영자 매뉴얼 - 페이지 4
{카테고리_이름} Clarus Technologies PCS-25에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarus Technologies PCS-25 14 페이지. Cleaning stations
Clarus Technologies PCS-25에 대해서도 마찬가지입니다: 운영자 매뉴얼 (16 페이지)
페이지 인쇄
I.
INTRODUCTION
Congratulations on your purchase of the Clarus PCS-25/WCS-25/PCS-15 Parts Cleaning
Stations! These Parts Washers are products of Clarus engineering and manufacturing.
They are made of the finest materials under a rigid quality control system. With proper
care they will give you long and satisfactory service.
To obtain the best use of your Parts Washers, please read this manual carefully. It will
help you become familiar with the operation of the equipment and contains many helpful
hints about Parts Washer maintenance.
The instructions and specifications contained in this manual were in effect as of
February 2000. Due to the policy of Clarus Technologies, LLC to continually improve
its products, however, modifications in these specifications may be made at any time.
This Operators Manual was compiled for your benefit. By reading and following the
safety, setup, operation, and trouble-shooting instructions described in the manual, you
should receive many years of trouble-free operation. Familiarize yourself with the
names of the Parts Washer components, which appear as capitalized terms throughout
this manual. Read this entire manual before attempting to start and operate the
Clarus Parts Washer.
II.
SPECIFICATIONS
– PCS-25/WCS-25 – PCS-15
S
PECIFICATIONS
Large format tank that uses 27.5 gallons of solvent, half the amount used in typical systems
Height/width/depth (inches) - 44/51/31 (Height to top of light 73")
150-watt halogen light
Single phase, 110V, 60 Hz, 5A
Dual canister high capacity filtration
Ultra fine 0.5-micron particulate filtration
Oven-baked polyester powder coat finish
High quality steel construction with stainless steel work surface
Two brushes on WCS-25, brush and flexible gooseneck nozzle on PCS-25
Bright stainless steel work surface for better visibility and no darkening from corrosion
Patent pending sump configuration for efficient sludge removal
On-board pump for easy removal of sludge and to minimize service requirements
Fluid level gauge with indicator for "Add 5 gallons" of make-up fluid
Leveling feet
Pressure gauge shows status of filter and when filter change out is needed
Instructions describing all operational procedures are provided on clearly marked decals
Constant flow system regardless of how clogged the filters are
Filter canisters inside tank provide spill containment during filter change-outs
CLARUS PARTS WASHER
OPERATOR'S MANUAL
4