Clarus Technologies PCS-35 운영자 매뉴얼 - 페이지 6

{카테고리_이름} Clarus Technologies PCS-35에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarus Technologies PCS-35 13 페이지. Agitating cleaning stations

Different types of gloves may be required for differently types of fluids. The

local safety supply source can recommend the appropriate protective gloves.

3. Flammable. For the safety of owners and operators NO SMOKING around or

near this equipment.

QUICK START GUIDE

Please read entire Quick Start Guide before beginning, this will avoid possible start up

problems.

1. Remove outer wrap.

2. Unbolt legs from pallet.

3. Remove Light Bar from packaging.

4. Remove all loose packing.

To install the light bar, attach it to the "Light Bar Bracket" located on the

center/backside of the Parts Washer unit. Nuts and bolts have been provided. Before

tightening the bolts, open the tank lid and secure it to the light bar fusible link. Do not

bend the fusible link. Tighten all bolts. Once the light bar is secured, connect the male

plug of the light bar to the female plug labeled "light bar" out of the electrical box.

1. Create a properly sized area for the Parts Washer to be located in. This area

should be a level, solid working area with sufficient overhead room for the light

bar. A 110 volt 15 amp circuit should be within 6 feet of this area.

2. Place the Parts Washer in working area with a forklift or pallet jack with front of

unit facing out.

3. Use front leveling feet to reduce any rocking from an uneven floor. The leveling

feet should not be used to raise the unit off the floor. Use Bubble level to level

Front/Back and Left/Right.

1. Once the unit is set in place, leveled and plugged in, you can fill it with solvent.

PCS-15 Parts Cleaning Stations require 17.5 gallons of solvent. PCS-25 and

WCS-25 Parts Cleaning Stations require 27.5 gallons of solvent. (NOTE! Fill

Parts Washer until fluid level gauge located on front, left corner reads full.)

2. Make sure both the cleaning bush and fluid nozzle are inside the tank before

turning the system on. Turn system on by depressing green "ON" button.