DirekTronik SX-SWE01B 운영 매뉴얼 - 페이지 13

{카테고리_이름} DirekTronik SX-SWE01B에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DirekTronik SX-SWE01B 20 페이지. Mixed input type-c vga hdmi, hdmi 2.0 hdbaset switch, support 4k@60hz yuv4:4:4, 18gbps, hdr

페이지 인쇄

Operating Instruction

⑤ DHCP ON/OFF

⑥ Apply: Click to confirm modified static IP

Note:When you click for DHCP ON,then IP Address,Net Mask Address,Gate Way Address frames all become

grey and can not be modified.

9. WEB Control

9.1 Change the IP address of your PC.

1). Connect the Ethernet port of HDBaseT switch to the Ethernet port on PC by a straight pin to pin

cable with RJ45 connectors.

2). Configure your PC as follows:

① Click Start > Control Panel > Network and Sharing Center.

② Click Change Adapter Settings.

③ Highlight the network adapter you want to use to connect to the device and click Change settings of this

connection.

3). The local Area commotion properties window for Network selection appears as below.

4). Click the Highlight Internet Protocol Version 4 (TCP/IPv4).

5). Click Properties.

6). Select Use the following IP Address for static IP addressing and fill in the details.

For TCP/IPv4 you can use any IP address in the range 192.168.1.1 to 192.168.1.255 (excluding 192.168.1.168).

7). Click OK.

8). Click Close.