Lenovo 7Z46 매뉴얼

{카테고리_이름} Lenovo 7Z46에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Lenovo 7Z46 8 페이지. Toolless friction rail v2
Lenovo 7Z46에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지)

ThinkSystem Toolless Friction Rail v2

Read guidelines first

Review the documentation that comes with the rack for safety and cabling information. Before you install the

server in a rack, read the following guidelines:

• Two or more people are required to install 2U/4U or larger devices in a rack.

• Some illustrations might differ from your server. All types of server are removed and installed in a similar

manner.

• See the Maintenance Manual for the maximum room air temperature.

• Install the server only in a rack that has perforated doors.

• Do not block any air vents, usually 15 cm (6 inches) of air space provides proper airflow.

• For horizontal rack:

– Plan the device installation starting from the bottom of the rack.

– Install the heaviest device in the bottom of the rack.

– Do not leave open space above or below an installed server in your rack. To help prevent damage to

server components, always install a filler panel to cover the open space and to help ensure proper air

circulation.

– Do not extend more than one device out of the rack at the same time.

• For vertical rack:

– Plan the device installation starting from the center of the rack.

– Install the heaviest device in the center of the rack.

– Do not leave open space on the left or right side of an installed server in your rack. To help prevent

damage to server components, always install a filler panel to cover the open space and to help ensure

proper air circulation.

• Do not place any objects on the top of the rack-mounted devices.

• Connect all power cords to properly wired and grounded electrical outlets.

• Do not overload the power outlet when installing multiple devices in the rack.

• Remove the rack doors and side panels to provide easier access during installation.

• Install the server in a rack that meets the following requirements:

– Minimum depth of 70 mm (2.76 inches) between the front mounting flange and inside of the front door.

– Minimum depth of 190 mm (7.48 inches) between the rear mounting flange and inside of the rear door.

– The maximum distance between the front and the rear EIA flange of the rack is 810 mm (31.9 inches).

– If you want to install the rails and a 0U PDU into the same rack, the rack must be 42U or higher/wider.

Safety notice

CAUTION:

Make sure the rails support your server model and use

safe practices when lifting

1 1