Lenovo Flex System x222 Compute Node 제품 설명서 - 페이지 24

{카테고리_이름} Lenovo Flex System x222 Compute Node에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Lenovo Flex System x222 Compute Node 33 페이지.

Light path diagnostics panel

For quick problem determination when you are physically at the server, the x222 Compute Node offers a

three-step guided path:

The Fault LED on the front panel of each server

The light path diagnostics panels, one for each server, as shown in the following figure

LEDs that are next to key components on the system board

The two light path diagnostics panels on the x222 are visible when you remove the server from the

chassis. One panel is for the upper server and one is for the lower server.

Figure 10. Location of x222 light path diagnostics panels

To illuminate the light path diagnostics LEDs, power off the server, slide it out of the chassis, and press

the power button. The power button doubles as the light path diagnostics remind button when the server

is removed from the chassis.

The meanings of the LEDs in the light path diagnostics panel are listed in the following table.

Table 13. Light path diagnostic panel LEDs

LED

Meaning

The light path diagnostics panel is operational.

S BRD

A system board error is detected.

MIS

A mismatch has occurred between the processors, DIMMs, or HDDs within the configuration (as

reported by POST).

NMI

A non-maskable interrupt (NMI) has occurred.

TEMP

An over-temperature condition occurs that was critical enough to shut down the server.

MEM

A memory fault has occurred. The corresponding DIMM error LEDs on the system board are also lit.

Flex System x222 Compute Node