ACORN AQUA A112408B/S-VR-UBL 설치, 작동 및 유지보수 지침 - 페이지 4

{카테고리_이름} ACORN AQUA A112408B/S-VR-UBL에 대한 설치, 작동 및 유지보수 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ACORN AQUA A112408B/S-VR-UBL 8 페이지. Vandal resistant refrigerated universal bi-level aquaaccess barrier free, wall mounted water cooler

페이지 인쇄

STANDARD WASTE CONFIGURATION

INSTALLATION:

Choose configuration; Remove and reinstall filler plate, item 30 , reverse drain assembly

if required for alternate mounting configuration.

1. Mount hanger bracket to wall horizontally level as shown in Roughing-In and Dimensional Drawing.

Note: Adjust height of bracket if bubbler outlet height is required to vary from that shown.

WARNING: Hanger Bracket MUST be securely anchored to wall with fasteners sufficient to support

3 times the weight of cooler. If wall can not provide adequate support, order and install optional

fixture support carrier.

2. Remove the bottom cover from the water cooler and set aside in a safe place. Save the screws

in a secure location for re-use in later stages of installation.

Hang the water coolers on the hanger brackets ensuring the bracket tabs engage AND seat in the

slots in the back of the water coolers. Note: Hanging of refrigerated unit first is recommended since

it is the heavier of the two. Verify water coolers are level, left to right AND front to back from bottom

of unit.

Caution: The bubbler stream may be adversely affected if units are not square and level. Bottom of

units and louvers should be used as reference to verify unit is square and plumb.

4. Anchor the water coolers to the wall at the lower mounting points in each back panel. Shim lower

mounting points to level unit if necessary.

5. Outlet tube from evaporator has an in-line tee with a tube going to refrigerated unit's valve and the

"TEE" not connected. Connect the loose supply tube from refrigerated unit to the "TEE".

6. Thoroughly flush the 3/8" O.D. supply line and then connect water cooler to water supply angle

stop valve (by others) with supplied 3/8" O.D. copper tube.

7. Use supplied flexible hose and clamps to connect waste tailpiece from upper unit to waste tailpiece

of lower unit and then make up 1-1/4" O.D. p-trap waste connection. Waste p-trap by others.

START UP:

1. Before connecting power supply and assembling bottom cover to water cooler, but after thoroughly

flushing the supply line and connecting it to the fixture, turn on building water supply and check all

connections for leaks.

2. Air within the water cooler system or the structure supply piping will cause an irregular bubbler

outlet stream until purged out by incoming water. Covering the bubbler with a clean cup (or

similar object) is recommended when first activating water cooler to prevent excessive splashing.

Depress the pushbutton until steady water stream is achieved.

3. If water flow requires adjustment, insert a slotted narrow blade screwdriver through the hole

centered on the pushbutton to the flow regulator. Turning clockwise will increase flow and turning

counterclockwise will decrease flow.

4. Recheck all water and drain connections with water flowing through system.

5. With power still NOT connected, carefully manually rotate cooling fan to insure proper clearance

and free fan action.

6. Plug water cooler in to electrical outlet and make sure unit begins to function.

7. Assemble bottom cover to water cooler with screws furnished.

ITEM 30

FILLER PLATE

Page 4 of 8

ITEM 30

FILLER PLATE

ALTERNATE WASTE CONFIGURATION