Nikon COOLSHOT 80 VR 사용 설명서 - 페이지 9

{카테고리_이름} Nikon COOLSHOT 80 VR에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Nikon COOLSHOT 80 VR 41 페이지.

[Measurement]

Caution — Controls, adjustments or usage of procedures other than those specified herein may

produce negative effects or damage to your health due to laser radiation.

*Before measuring, be sure to confirm each mode setting.

* Please refer to each section on how to set each mode.

■ Adjusting diopter

Adjust the diopter to obtain a clear internal display in the viewfinder.

First, rotate the diopter adjustment ring counterclockwise until it comes to a complete stop.

Next, turn on the power and rotate the diopter adjustment ring back and forth until the internal

display comes into focus.

1. Turn on the power.

(Automatic power shut-off after approx. 8 seconds

unoperated.)

Immediately after power-on

Standby

3. Pressing the PWR button starts measurement.

After measurement, the result is displayed for approx. 8 seconds, then power automatically turns off.

If you press the PWR button during power-on, another measurement starts.

2. Aim at the target.

Position the target at the center of the

target mark.

Pressing the PWR button once starts single measurement, then displays the results.

Press and hold down the

to start continuous measurement up to approx. 8 seconds.

PWR button

During measurement, the measured result is displayed consecutively while the laser irradiation mark is

blinking. If you release your finger from the button, continuous measurement stops.

Press PWR button once

Standby

Press and hold down the PWR button

When measuring a flagstick at a golf course, for example, keep targeting the

flagstick at the center of the target mark with the continuous measurement

function to minimize handshake.

Example of measured

Example of measurement

distance display

failure

Single measurement

Continuous measurement