DIRTY HANDS 104609 운영 매뉴얼 - 페이지 11
{카테고리_이름} DIRTY HANDS 104609에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DIRTY HANDS 104609 20 페이지.
Operation
Overload Indicator Light
The total combined load through the outlet on the generator must
not exceed the rated maximum power of the unit.
Calculating Power Draw
Power draw can be calculated by multiplying volts and amps. The
resulting number is wattage.Never exceed the rated maximum
wattage for the generator or outlet.
Note: Long power cords and extension cords draw additional
power. Keep cord length at a minimum
The overload indicator light comes on when an overload of a
connected electrical device is detected, the inverter unit overheats,
or the AC output voltage rises. The electronic breaker will activate,
stopping power to the generator and any connected electric devices.
The output pilot light (green) will flicker and the overload indicator
light (red) will turn on, then the engine will stop running.
If this occurs, please follow the following steps:
1. Turn off any connected electric devices and stop the engine
2. Reduce the total wattage of connected electric devices within the
application range.
3. Check for blockages in the cooling air inlet and around the
control unit. If any blockages are found, remove.
4. After checking, restart the engine.
The generator AC output automatically resets
when the engine is stopped and then restarted.
The overload indicator light may come on for a few seconds at first
when using electric devices that require a large starting current.
Stopping The Engine
1. Turn off the power switch(es) of connected electronic devices
and disconnect electric devices from the generator.
2. Turn the engine switch to "STOP" position.
3. Turn the fuel On/Off lever to "OFF".
4. Turn the fuel tank cap air vent counterclockwise to the
"CLOSED" position.
5. Allow a few minutes for cool down before tyransporting,
avoiding the muffler area which may be hot.
!
CAUTION
11