DIRTY HANDS 104609 Manual de operação - Página 11

Procurar online ou descarregar pdf Manual de operação para Gerador portátil DIRTY HANDS 104609. DIRTY HANDS 104609 20 páginas.

Operation

Overload Indicator Light

The total combined load through the outlet on the generator must

not exceed the rated maximum power of the unit.

Calculating Power Draw

Power draw can be calculated by multiplying volts and amps. The

resulting number is wattage.Never exceed the rated maximum

wattage for the generator or outlet.

Note: Long power cords and extension cords draw additional

power. Keep cord length at a minimum

The overload indicator light comes on when an overload of a

connected electrical device is detected, the inverter unit overheats,

or the AC output voltage rises. The electronic breaker will activate,

stopping power to the generator and any connected electric devices.

The output pilot light (green) will flicker and the overload indicator

light (red) will turn on, then the engine will stop running.

If this occurs, please follow the following steps:

1. Turn off any connected electric devices and stop the engine

2. Reduce the total wattage of connected electric devices within the

application range.

3. Check for blockages in the cooling air inlet and around the

control unit. If any blockages are found, remove.

4. After checking, restart the engine.

The generator AC output automatically resets

when the engine is stopped and then restarted.

The overload indicator light may come on for a few seconds at first

when using electric devices that require a large starting current.

Stopping The Engine

1. Turn off the power switch(es) of connected electronic devices

and disconnect electric devices from the generator.

2. Turn the engine switch to "STOP" position.

3. Turn the fuel On/Off lever to "OFF".

4. Turn the fuel tank cap air vent counterclockwise to the

"CLOSED" position.

5. Allow a few minutes for cool down before tyransporting,

avoiding the muffler area which may be hot.

CAUTION