Cub Cadet Domestic Series 7000 서비스 매뉴얼 - 페이지 11

{카테고리_이름} Cub Cadet Domestic Series 7000에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet Domestic Series 7000 13 페이지. Compact tractor
Cub Cadet Domestic Series 7000에 대해서도 마찬가지입니다: 서비스 매뉴얼 (4 페이지)

페이지 인쇄

INSTALL THE SHIFT LOCK PLATE

5.1.

With the gear selector in Low, position the shift

lock plate as follows: See Figure 5.1.

•

The shift lock plate mounts inboard of the shift

lever, with the notches facing outward, to lock

the lever in position.

•

The rear notch of the plate should just contact

the front edge of the shift lever.

•

There should be sufficient clearance between

the notch in the shift plate and the edge of the

slot in the fender console to allow the shift lever

to pass.

•

Do not bend the shift lock plate to follow the con-

tour of the fender.

shift lock plate

fender

console

notch

Figure 5.1

5.2.

Mark and punch the fender console at the center

of the rear hole in the shift lock plate.

5.3.

Move the shift lever to the Neutral position.

5.4.

Drill a 3/16" hole at the spot that was just marked

and punched.

5.5.

With the counter-sunk side of the shift lock plate

facing up, attach it to the fender console using

the flat-head screw, washer, and locking nut pro-

vided in the kit. See Figure 5.5.

5.6.

Bow the shift lock plate so that it follows the con-

tour of the fender console. Position the loose

end of the shift lock plate so that there is suffi-

cient clearance for the shift lever to pass the

notch that will hold it in High range.

5.7.

Mark, punch,. and drill the second hole in the

console.

5.8.

Secure the loose end of the shift lock plate to the

fender console using the flat-head screw,

washer, and locking nut supplied in the kit.

See Figure 5.8.

7000 High / Low Shift Kit

Figure 5.5

Figure 5.8