Armstrong Air BCS2 Series 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} Armstrong Air BCS2 Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Armstrong Air BCS2 Series 15 페이지.
페이지 인쇄
Before Conversion
1.
Remove and set aside blower and coil access covers.
2.
Remove the coil support bracket.
3.
Remove coil assembly, bottom drain pan and side drain
pan as one assembly from the air handler.
Caution: equipment damage, or personal injury. Take
care when removing coil assembly from unit. Installation in
this configuration may cause the coil to tip into unit once
clear of the cabinet. Support the coil when removing.
4.
Move side drain pan to the opposite side
5.
Install modified coil assembly back into air handler in the
same orientation as before.
6.
Install the coil support bracket on the opposite side of
the air handler.
5
For models 2.5 thru 5 ton the bracket attached to
NOTE:
the top plate will need to be switched to the opposite side
of the coil. This is to prevent blowoff in the horizontal
position when the airflow is changed from left hand to right
hand.
7.
Determine knockouts required for drain line
connections. Knock out and install drain lines.
8.
Replace the blower and coil access covers.