ARMTEL ARMT.665200.104UM 사용자 설명서 - 페이지 13

{카테고리_이름} ARMTEL ARMT.665200.104UM에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ARMTEL ARMT.665200.104UM 20 페이지. 8 fuse module

2 INTENDED USE

2.1.1 8 Fuse module shall be used under exposure factors and ambient

parameters which do not exceed permissible values given in Table 1.

2.1.2 The requirements for operating conditions and the choice of the place of

installation given in this document take into account the most typical factors that

affect the operation of the 8 Fuse module.

Factors that cannot be predicted, estimated, or verified, and which the manufacturer

was unable to factor in during development may exist or arise during operation at the

operating facility.

In the event of such factors, find another operating site where said factors do not exist

or do not affect the operation of the product.

Preparation of 8 Fuse module for use is carried out by representatives of the

manufacturer, or by personnel who have been trained (instructed) in the operation of

products of Armtel LLC. The main preparation of the product for use is carried out during

installation and connection. Preparation of 8 Fuse module for work includes several activities:

1. Removing 8 Fuse module and connection cables from the shipping container.

2. Removing 8 Fuse module and connection cables from the customer package.

3. Check the scope of supply of 8 Fuse module according to the product passport.

4. Conduct an external inspection of the product for the absence of damage (cracks,

dents, etc).

5. Install the 8 Fuse module at the place of operation (snap on the DIN rail). The place

in the cabinet should be chosen taking into account the convenience of access to

the module for connecting wires, as well as for maintenance.

6. Connect the common power cable to the terminal block X4, and the power cables

of the actuators to the terminal block X1. In the case of using an additional 8 Fuse

module, connect the same-name contacts of the terminal block X2 of the

additional module and the contacts of the terminal block X3 of the main 8 Fuse

module with wires of the required length with a cross-section of at least 0.2 mm

7. In the passport, make notes about the place and time of installation of the module

8 fuses.

armtel.com

MODULE

8 FUSE

User Manual

ENG

page 11/16