ARMTEL ARMT.665200.104UM Посібник користувача - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник користувача для Блок управління ARMTEL ARMT.665200.104UM. ARMTEL ARMT.665200.104UM 20 сторінок. 8 fuse module
Друкувати сторінку
2 INTENDED USE
2.1 Operating limits
2.1.1 8 Fuse module shall be used under exposure factors and ambient
parameters which do not exceed permissible values given in Table 1.
2.1.2 The requirements for operating conditions and the choice of the place of
installation given in this document take into account the most typical factors that
affect the operation of the 8 Fuse module.
Factors that cannot be predicted, estimated, or verified, and which the manufacturer
was unable to factor in during development may exist or arise during operation at the
operating facility.
In the event of such factors, find another operating site where said factors do not exist
or do not affect the operation of the product.
2.2 Preparation for use
Preparation of 8 Fuse module for use is carried out by representatives of the
manufacturer, or by personnel who have been trained (instructed) in the operation of
products of Armtel LLC. The main preparation of the product for use is carried out during
installation and connection. Preparation of 8 Fuse module for work includes several activities:
1. Removing 8 Fuse module and connection cables from the shipping container.
2. Removing 8 Fuse module and connection cables from the customer package.
3. Check the scope of supply of 8 Fuse module according to the product passport.
4. Conduct an external inspection of the product for the absence of damage (cracks,
dents, etc).
5. Install the 8 Fuse module at the place of operation (snap on the DIN rail). The place
in the cabinet should be chosen taking into account the convenience of access to
the module for connecting wires, as well as for maintenance.
6. Connect the common power cable to the terminal block X4, and the power cables
of the actuators to the terminal block X1. In the case of using an additional 8 Fuse
module, connect the same-name contacts of the terminal block X2 of the
additional module and the contacts of the terminal block X3 of the main 8 Fuse
module with wires of the required length with a cross-section of at least 0.2 mm
7. In the passport, make notes about the place and time of installation of the module
8 fuses.
armtel.com
MODULE
8 FUSE
User Manual
ENG
2
.
page 11/16
© Armtel