Cub Cadet 221 LHP 운영자 매뉴얼 - 페이지 8
{카테고리_이름} Cub Cadet 221 LHP에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet 221 LHP 20 페이지. Single stage snow thrower
Cub Cadet 221 LHP에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지), 운영자 매뉴얼 (20 페이지), 사양 (2 페이지), 운영자 매뉴얼 (20 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. Safe Operation Practices
- 2. Clearing Clogged Discharge Chute
- 2. Maintenance & Storage
- 2. Safety Symbols
- 3. Assembly & Set-Up
- 4. Controls & Features
- 5. Operation
- 6. Maintenance & Adjustment
- 7. Customer Support
- 8. Dealer
- 9. Service
- 10. Troubleshooting
- 11. Replacement Parts
- 12. Warranty
Installing the Chute
1.
Remove the hex washer screws in the chute base. See Fig.
3-4.
Hex Washer
Screw
2.
Align the holes in the chute base with the holes in the
lower chute and secure with the previously removed hex
washer screws. See Fig. 3-5.
8
s
3— a
ectiOn
sseMbly
Figure 3-4
Figure 3-5
& s
-u
et
p
Installing the Chute Rotation Control Assembly
1.
Remove the four hex washer screws from the back of the
handle (two on each side). See Fig. 3-6.
Figure 3-6
2.
Using the four hex washer screws, install the chute rotation
control assembly. See Fig. 3-7.
Figure 3-7