Cub Cadet 221 LHP 운영자 매뉴얼 - 페이지 9
{카테고리_이름} Cub Cadet 221 LHP에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet 221 LHP 20 페이지. Single stage snow thrower
Cub Cadet 221 LHP에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지), 운영자 매뉴얼 (20 페이지), 사양 (2 페이지), 운영자 매뉴얼 (20 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. Safe Operation Practices
- 2. Clearing Clogged Discharge Chute
- 2. Maintenance & Storage
- 2. Safety Symbols
- 3. Assembly & Set-Up
- 4. Controls & Features
- 5. Operation
- 6. Maintenance & Adjustment
- 7. Customer Support
- 8. Dealer
- 9. Service
- 10. Troubleshooting
- 11. Replacement Parts
- 12. Warranty
3.
Remove the screw and hex lock nut from the universal
joint. See Fig. 3-8.
Hex Lock Nut
Screw
Hex Lock Nut
Chute Rod
Figure 3-8
NOTE: Make sure the chute is facing forward when
installing the universal joint.
4.
Install the universal joint on the end of the chute rod as
shown in Fig. 3-8.
NOTE: Be sure the holes in the universal joint line up with
the holes in the chute rod. You may have to activate the
trigger to allow you to line up the holes.
5.
Secure the universal joint with the hex nut and screw
previously removed. See Fig. 3-8.
Figure 3-9
6.
Slide the rubber bellow over the universal joint. See Fig.
3-9.
Universal Joint
Screw
Rubber Bellow
Installing the Recoil Starter Handle
1.
Remove the eye bolt and handle knob from the manual
bag.
2.
Place the eye bolt and handle knob on the upper handle as
shown in Fig. 3-10. Do not fully tighten the hardware until
instructed to do so.
Recoil Starter Handle
Eye Bolt
Handle
Knob
Figure 3-10
NOTE: The opening of the eye bolt should face toward the
back of the snow thrower.
3.
Slowly pull the recoil starter handle up towards the eye
bolt.
4.
Slip the recoil starter rope into the eye bolt from the back
of the snow thrower. See Fig. 3-10.
5.
Securely tighten the eye bolt and handle knob.
s
ectiOn
3 — a
& s
-u
sseMbly
et
p
9