Cub Cadet 221 LHP 운영자 매뉴얼 - 페이지 9

{카테고리_이름} Cub Cadet 221 LHP에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet 221 LHP 20 페이지. Single stage snow thrower
Cub Cadet 221 LHP에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지), 운영자 매뉴얼 (20 페이지), 사양 (2 페이지), 운영자 매뉴얼 (20 페이지)

페이지 인쇄

Using the four hex washer screws, install the chute rotation

control assembly. See Figure 3-8.

Figure 3-8

Remove the screw and hex lock nut from the universal

joint. See Figure 3-9.

Hex Lock Nut

Screw

Hex Lock Nut

Chute Rod

Figure 3-9

NOTE: Make sure the chute is facing forward when

installing the universal joint.

Install the universal joint on the end of the chute rod as

shown in Figure 3-9.

NOTE: Be sure the holes in the universal joint line up with

the holes in the chute rod. You may have to activate the

trigger to allow you to line up the holes.

Secure the universal joint with the hex nut and screw

previously removed. See Figure 3-9.

Universal Joint

Screw

Slide the rubber bellow over the universal joint. See Figure

3-10.

Figure 3-10

Installing the Recoil Starter Handle

Remove the eye bolt and handle knob from the manual bag.

Place the eye bolt and handle knob on the upper handle

as shown in Figure 3-11. Do not fully tighten the hardware

until instructed to do so.

Recoil Starter Handle

Eye Bolt

Handle

Knob

Figure 3-11

NOTE: The opening of the eye bolt should face toward the

back of the snow thrower.

Slowly pull the recoil starter handle up towards the eye

bolt.

Slip the recoil starter rope into the eye bolt from the back

of the snow thrower. See Figure 3-11.

Securely tighten the eye bolt and handle knob.

ection

Rubber Bellow

3 — A

& S

-U

SSembly