Blade 350 QX3 사용 설명서 - 페이지 5

{카테고리_이름} Blade 350 QX3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Blade 350 QX3 16 페이지.
Blade 350 QX3에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

Charging the Flight Battery

AP C

b )

Charger Speciﬁ cations

• Input Voltage: 10.5–15V DC

• Charge Current: 3.5A

1. Connect the AC power supply to the charger.

2. Connect the AC power supply to an AC power source.

The green LED blinks.

3. Connect the battery to the charger. The red LED

blinks, indicating charging. When the battery nears

full charge, the red and green LEDs blink, indicating

cell balancing.

4. Disconnect the battery when the green LED glows

solid.

Charger LED Codes

Green Blinking: Power connected

Red Blinking: Charging

Red & Green Blinking: Cells balancing

Green Solid: Charging complete

Red Solid: Error

batteries can result in a ﬁ re, personal injury and/or

property damage.

NOTICE: If using a battery other than the included

Li-Po battery, refer to your battery manufacturer's

instructions for charging.

• Slide the gimbal on the mount rails until it locks.

• Connect the wiring harness to the plug on the bottom

of the 350 QX3.

• To remove the gimbal, press the tab at the front of

the mount and slide the gimbal forward.

• Install 4 AA batteries in the transmitter as shown.

The Battery Charging Process

CAUTION: All instructions and warnings must

be followed exactly. Mishandling of Li-Po