Cub Cadet 521E 운영자 매뉴얼 - 페이지 5

{카테고리_이름} Cub Cadet 521E에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet 521E 20 페이지. Single stage snow thrower
Cub Cadet 521E에 대해서도 마찬가지입니다: 운영자 매뉴얼 (20 페이지)

페이지 인쇄

1. Parts List

SECTION 2: ASSEMBLING YOUR SNOW THROWER

Unpacking from carton

•

Cut along corners of the carton and lay it down flat.

See Figure 1. Remove packing material.

•

Remove any loose parts included with unit (i.e.,

operator's manual, etc.).

•

Roll unit out of carton. Check carton thoroughly for

any remaining loose part.

Remove loose parts

Figure 1

Hardware pack

(Figure 2)

1. Ignition Keys (2)

NOTE: One key is in the switch on the snow thrower.

2. Eyebolt

3. Saddle Washer 5/16" I.D.

4. Hex Nuts 5/16-18 Thread (2)

5. Cotter Pin

Ignition

Key

Eye Bolt

Figure 2

Items required for assembly

1. Pair of pliers (not necessary, but helpful)

2. Two cycle engine oil

3. Fresh gasoine

NOTE: All references to left or right side of the snow

thrower is from the operating position only.

Raising upper handle

•

Loosen the hand knob on each side of the handle.

Remove packing material, if any.

Roll unit out

Hex Nut

Saddle

Washer

Cotter

•

Raise the upper handle in the direction shown in

Figure 3 till it clicks into the operating position.

Make sure not to pinch or crimp the cable.

•

Tighten the hand knobs.

Attaching control cable

The control cable may already be attached to the

control handle. If not attached, complete the following

steps to attach it to the snow thrower control housing.

Bottom

Hole In

Control

Handle

Control

Housing

•

Route the control cable over the lower handle.

Insert the end of the cable into the hole in the

control housing as shown in Figure 4. Push the

plastic fitting until it locks into the control housing.

•

Lift the control handle up, and hook the "Z" end of

the control cable into the bottom hole in the

control handle, from the outside to the inside. If

necessary, pull up on the end of the cable with a

pair of pliers to obtain slack in order to hook it into

Raise

handle

to here

Hand Knobs

Figure 3

"Z" End

of Cable

Plastic

Fitting

Figure 4