Cub Cadet 521E 운영자 매뉴얼 - 페이지 6

{카테고리_이름} Cub Cadet 521E에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet 521E 20 페이지. Single stage snow thrower
Cub Cadet 521E에 대해서도 마찬가지입니다: 운영자 매뉴얼 (20 페이지)

페이지 인쇄

1. Parts List

the control handle. Hold the "Z" fitting with the

pliers, not the cable, to avoid damaging the cable.

NOTE: The upper hole in the control handle provides

for adjustment in belt tension. Refer to Belt Tension

Adjustment Section of this manual for instructions.

Installing chute crank

•

Thread one 5/16" hex nut all the way onto the

eyebolt. See Figure 5. All necessary hardware is

included in the hardware pack shipped with your

unit. See Figure 2 for more details.

•

Slide the eyebolt onto the chute crank. Insert

eyebolt into the hole in the lower handle.

Eye Bolt

Hex

Nuts

Figure 5

•

Insert the chute crank into the coupler at the top

right side of the snow thrower. See Figure 6.

•

Rotate the crank to align holes, and insert the

cotter pin. Bend ends of cotter pin in opposite

directions to secure. See Figure 6.

Cotter Pin

Coupler

Figure 6

Chute Crank

Saddle

Washer

Chute Crank

•

Secure eyebolt with 5/16" saddle washer and hex

nut. The cupped side of washer goes against the

handle. Adjust lower hex nut until the eyebolt is

positioned so that the chute crank turns freely

(does not bind).

•

Move upper hex nut down against the lower

handle. Tighten lower hex nut securely.

Assembling the chute

The snow thrower has been shipped with the upper

chute pivoted all the way down. Assemble as follows:

•

Turn the chute crank until the chute faces straight

to the front. See Figure 7.

Hand

Knob

Front

Upper

Chute

•

Remove the hand knob, flat washer and carriage

bolt from the upper chute. See Figure 7.

•

Pivot the upper chute up so that there is no gap

between the upper and the lower chute. See

Figure 8. Secure with hardware just removed.

Pivot

upper

chute

Flat

Washer

Carriage

Bolt

Figure 7

Gap

Figure 8