DiscoSmash DSG-X10 사용자 설명서

{카테고리_이름} DiscoSmash DSG-X10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DiscoSmash DSG-X10 2 페이지.

DSG-X10 User Manual

• Connections:

The soundbox can be connected in 2 ways:

1. If you have a Discosmash mixing panel:

Use the AMP-DS connector. This connects to the "EXT" connection of the mixing panel.

The Output, Input and Power connections are not used.

2. If you don't have a Discosmash mixing panel:

You need to connect the output of the CD-player (or other music source) to the Input of the

soundbox. The Output of the soundbox connects to your mixing panel or amplifier, where

the CD-player was previously connected. A 9V AC power adapter is connected to the

Power connection.

The Ext. connector is for external expansions and won't be used in most cases.

The Remote connector can be used to activate a sound remotely by shorting the 2 pins.

(i.e. with an external switch or relays contact)

• General:

Make sure there is a SD memory card with the correct contents in the slot.

On start-up first the software version will be displayed.

After this, if the card can be read correctly, the selected bank will be displayed ("b01"

means that bank 1 is now active).

Each of the 10 buttons will activate a sound. The volume + and - buttons will change the

volume (between 0 and 50) and save it.

Discosmash

Vroegeinde 14, 2243 Pulle, Belgium

Tel.: +32 (0)3 4640909 - Fax: +32 (0)3 4640139

[email protected] - www.discosmash.com