Discount Car Stereo A2D-JAG97 빠른 시작 매뉴얼 - 페이지 4
{카테고리_이름} Discount Car Stereo A2D-JAG97에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Car Stereo A2D-JAG97 7 페이지. Music streaming for select 1986-97 jaguar
페이지 인쇄Installing module to radio CD socket:
Click
here
to remove radio or click link below for dash removal instruction video.
XK models differ slightly.
https://www.youtube.com/watch?v=vpAIdr6V3iE
Disconnect CD changer plug (See Fig. 1) from radio socket (See Fig. 2)
1.
Connect CD changer plug (See Fig. 1) to module 8-pin socket (See Fig. 4)
2.
Connect module 8—pin plug (See Fig. 1) to CD socket (See Fig. 2)
3.
Connect/splice or tap red wire (See Fig. 5) to vehicles 12V accessory
4.
(switched) supply.
12V accessory is available on radio power harness (usually Green/Orange,
purple, red/white etc. Use a voltmeter or test light to verify voltage
condition prior to finalizing install.
Do not connect module red wire to 12V battery (always on).
Proceed to pairing
5.
Fig. 5
Pairing
Pairing process varies among devices but basic steps are the same. This
process is done upon initial install and will not have to be repeated.
1.
Turn ignition and radio "ON"
LED inside module peephole will flash (pairing mode)
Settings, Wireless & Networks, Bluetooth Settings
2. Go to device:
3. Select
Bluetooth
and turn it "ON" (if not already ON).
Scan for devices
4. Tap
.
5. Wait for Bluetooth device name to appear (See below) and tap.
LED inside module peephole glow steady.
Note: It is possible to pair multiple devices, but only one connection is supported.
Pairs automatically with device to which it was most recently connected.
OR