Discount Car Stereo A2DIY-CR12 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Discount Car Stereo A2DIY-CR12에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Car Stereo A2DIY-CR12 8 페이지. Bluetooth kit for porsche cr-1 and cr-2 radios

페이지 인쇄

3. Connect push button 1/8" plug to Module "CTR" jack (See Fig. 4), route

button to front of the dash, remove tape backing, clean are and attach

button to surface (cable is 6ft. long). (See Fig. 5)

Fig. 5

push button

5. Use clip to install microphone to visor or headliner and route cable down

pillar, under dashboard toward module location and connect to module

"MIC" input.

Exercise caution when routing microphone so to not damage the

cable. Also ensure no ventilation duct is pointed towards

microphone.

Microphone

Fig. 6

Fig. 4

module

Optional push button with built-in microphone

For added installation flexibility, we offer optional push button with built-in

microphone seen in images below. This option replaces conventional visor

microphone and separate push button shown in Fig. 5 and 6. ages; which

means button can be placed on dashboard within driver reach or custom

installed nearby. Connect 1/8" plug to module "MIC/CTR" jack (See Fig. 4),

route to dash area (cable is 6ft. long); clean surface, remove tape backing and

attach to dash. (To add this option to cart, simply tap option on order page)

6. Disconnect (car side) 8-pin plug from radio 8-pin connector (See Fig. 7)

Radio harness 8-pin connectors

Fig. 7