Discount Car Stereo A2DIY-JAG98 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} Discount Car Stereo A2DIY-JAG98에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Car Stereo A2DIY-JAG98 11 페이지. Bluetooth 1997-06 xk (x100)and 1998-03 xj (x308) with cd changer
Discount Car Stereo A2DIY-JAG98에 대해서도 마찬가지입니다: 빠른 시작 블루투스 설치 매뉴얼 (11 페이지)
페이지 인쇄Installing Bluetooth Module
In our 2001 XJR test vehicle with Premium Audio, the Bluetooth module was
installed in armrest (See Fig. 10). In this area you will also find factory
phone plug (See Fig. 11) and cigar lighter, either of which can be used to
power module (see Fig. 10).
Fig. 10
Fig. 11
1.
Connect/Tap module
Red wire to
connect to constant battery supply)
If vehicle has phone plug, use chart below to tap module accessory
wires. Always test prior to making
Factory connector/Plug
Accessory wire
10-pin Female (white)
Pin 10 (light green)
10-pin Male (yellow)
Pin 10 (white/green)
14-pin (yellow)
Pin 13 (Green)
18-pin male (yellow)
Pin 5 (Green)
12V Accessory supply
(Do not
connection.
Ground wire
Pin 6 (black)
Pin 6 (black)
Pin 11 (black)
Pin 11 (black)
2. If vehicle does not have a phone plug, use cigar lighter power lines
under console:
Tap module's
Red wire
to White/Blue= 12V ACC
Fig. 12
Note: Cigar lighter power may introduce noise into the system. This is not the result of
a faulty module but vehicles electrical system. Find a clean power/ground supply (we
recommend factory phone plug). If engine noise is still an issue, consider adding this
noise filter
or similar.
3. Connect audio module 8-pin DIN plug routed from trunk (See Fig. 4) to
Bluetooth module female connector seen in Fig. 13