Aereco HAT-200-C 기술 및 유지보수 문서 - 페이지 7

{카테고리_이름} Aereco HAT-200-C에 대한 기술 및 유지보수 문서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aereco HAT-200-C 12 페이지.

TECHNICAL AND MAINTENANCE DOCUMENTATION HAT

STER

To open the housing of HD automated unit use a screwdriver. Do not use a power screw-

driver because of the danger of damaging the screws and loss of tightness of the casing.

1 PG11 cable gland enables connection of 1x230 V power supply. The power wires should

be connected to the corresponding terminal blocks 2, in accordance with point 4 of the

technical and propulsion documentation. The potentiometer 3 is used to change the setting

of the base pressure. The base pressure is preset at the factory. Do not change the default

connections 4. The automated system is equipped with a switch 5. The switch button is

located on the lid of the casing.

www.aereco.com

PE PE L N

ZAS

N L

ATTENTION!!!

After connecting the power

supply, mount the cover of the

automated system and tighten

it with screws with 0.8 Nm

force.