Aereco HAT-200-C 기술 및 유지보수 문서 - 페이지 8

{카테고리_이름} Aereco HAT-200-C에 대한 기술 및 유지보수 문서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aereco HAT-200-C 12 페이지.

5. START-UP

Incorrect start-up can lead to damage of the fan.

The start-up can be carried out by the AERECO service with prior agreement.

Before applying voltage you have to check that:

installation materials, possible waste and tools have been removed from inside the fan,

the fan impeller turns easily without rubbing or jamming,

the fan is securely mounted,

the direction of air flow through the fan corresponds to the installation design,

electrical connections have been made correctly,

the wire fixing is secure and made using the correct materials,

electric wires connected to the fan are properly fastened, without risk of breaking or

fraying due to vibrations,

the protective (earthing) conductor and possibly also the equipotential bonding con-

ductor are correctly connected to the fan and to the grounding point (busbar)

safety devices have been installed and they comply with the general safety regulations

and the requirements of section 4 of the documentation,

the voltage supply corresponds to the rated values within the tolerances: max. voltage

+ 6%, - 10% according to EN 60038:2012 (unless other tolerances are indicated on

the nameplate of the fan).

After applying voltage you have to check that:

the fan works without any abnormal sounds.

TECHNICAL AND MAINTENANCE DOCUMENTATION HAT

ATTENTION!!!

Start-up must be documented

by an entry in the warranty

card.

Causing damage to the fan

as a result of installation error

or the use of inappropriate

electrical

protection

grounds for invalidating the

guarantee.