Discount Equipment CD-5 매뉴얼 - 페이지 12

{카테고리_이름} Discount Equipment CD-5에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Equipment CD-5 13 페이지. Air powered chip-dek scabbler

페이지 인쇄

TUNGSTEN CARBIDE BITS

5 -

POINT

Item no. 18810

General surface removal

Penetration up to 1 /4 inch.

9 - POINT

Item no. 18820

Laitance removal

Fine scabbling

Anti-slip surfacing

Penetration to 1 /8 inch.

CROSS-CUT

Item no. 18830

Demolition -

Fast, Rough Surface

removal. Grooving -

Repairs to spalled and

deteriorated slabs.

E-CDS-IP-6/98

Use 5-Point bits for general purpose

removal of concrete due to spalling,

blistering, excess surface material, or in

preparation of bonding new concrete

overlays. Depth of removal is generally

1 /4" or more and is dependent on the

speed with which the unit is moved

across the surface.

The 9-Point bits achieve surface

removal of approximately 1 /8". Creating

an excellent bonding texture for

overlays of thin coats of polymer

concrete, epoxy or urethane. Also ideal

for producing slip-resistant surfaces for

fork trucks and other vehicular traffic.

CROSS-CUT bits may be used for fast,

heavy surface removal of concrete for

new overlays, repairs to deteriorated

=' - ' . ,..""' " ""

slabs, or roughening dairy barn floors to

help prevent cattle from slipping. Depth

of removal is generally 3/8" or greater

dependent on speed with which unit is

moved across the surface.

Bits are easily and quickly changed or replaced. The uses listed above are merely suggested.

Your own trials will determine which bit fits your need best. Choose the correct type to do the

job. Use a hammer and punch to drive out the bit retaining pins. Remove the bits, replace and

drive the retaining pins back in securely. If pins are loose or worn replace with new tight fitting

pins.

Page 10