Discount Equipment CD-5 Manual - Página 12
Procurar online ou descarregar pdf Manual para Máquina de chão Discount Equipment CD-5. Discount Equipment CD-5 13 páginas. Air powered chip-dek scabbler
Imprimir páginaTUNGSTEN CARBIDE BITS
5 -
POINT
Item no. 18810
General surface removal
Penetration up to 1 /4 inch.
9 - POINT
Item no. 18820
Laitance removal
Fine scabbling
Anti-slip surfacing
Penetration to 1 /8 inch.
CROSS-CUT
Item no. 18830
Demolition -
Fast, Rough Surface
removal. Grooving -
Repairs to spalled and
deteriorated slabs.
E-CDS-IP-6/98
Use 5-Point bits for general purpose
removal of concrete due to spalling,
blistering, excess surface material, or in
preparation of bonding new concrete
overlays. Depth of removal is generally
1 /4" or more and is dependent on the
speed with which the unit is moved
across the surface.
The 9-Point bits achieve surface
removal of approximately 1 /8". Creating
an excellent bonding texture for
overlays of thin coats of polymer
concrete, epoxy or urethane. Also ideal
for producing slip-resistant surfaces for
fork trucks and other vehicular traffic.
CROSS-CUT bits may be used for fast,
heavy surface removal of concrete for
new overlays, repairs to deteriorated
=' - ' . ,..""' " ""
slabs, or roughening dairy barn floors to
help prevent cattle from slipping. Depth
of removal is generally 3/8" or greater
dependent on speed with which unit is
moved across the surface.
Bits are easily and quickly changed or replaced. The uses listed above are merely suggested.
Your own trials will determine which bit fits your need best. Choose the correct type to do the
job. Use a hammer and punch to drive out the bit retaining pins. Remove the bits, replace and
drive the retaining pins back in securely. If pins are loose or worn replace with new tight fitting
pins.
Page 10