3D AEROWORKS Pilatus PC-21 조립 설명서 및 사용자 설명서 - 페이지 7

{카테고리_이름} 3D AEROWORKS Pilatus PC-21에 대한 조립 설명서 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D AEROWORKS Pilatus PC-21 19 페이지.

3D AEROWORKS Pilatus PC-21 조립 설명서 및 사용자 설명서
3
Cut 15mm sections of skewer and place into alignment holes in the fuselage sections.
NOTE - It may be required to open up the holes a small amount if the fit is too tight. Do this
by using a 3mm drill bit. Gently spin it in reverse as you insert it into the hole. This will ensure
the bit does not tear the print.
Test fit the sections of the fuse before gluing to ensure a clean fit.
4
Glue all sections of the fuse together except fuse 1. This will be glued on last in order to
allow for cg balancing.
5
Once glued, with a sharp knife, remove the false floor of the battery hatch. (see pic/
highlighted faces) NOTE: The removed sections of LW-PLA that is the false floor will be
used as hinge pieces later. Do not throw away.