3D AEROWORKS TRACER 2000 조립 설명서 및 사용자 설명서 - 페이지 12

{카테고리_이름} 3D AEROWORKS TRACER 2000에 대한 조립 설명서 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D AEROWORKS TRACER 2000 19 페이지. Thermal glider

Install the tail boom to the rear of the fuse. There is an optional small hole in the aft of the

fuse for a M2x20mm screw to secure the tail boom to the fuse, otherwise the tail boom can

be glued in place. Be sure to confirm the v-tail is level with the fuse before fixing the tail in

place.

Place tape at the end of each elevator to hold it level while connecting the fishing line to the

elevator. It is advised that the servo's be centered and programmed before connecting the

control lines. Place a drop of CA on the knot to secure it. The knot should be firm and not

overly tight, if it is too tight you risk adjusting the angle of the tail-plane which could lead to

adverse flying characteristics.