Arnott P-2210 설치 매뉴얼 - 페이지 2
{카테고리_이름} Arnott P-2210에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Arnott P-2210 6 페이지. Air suspension compressor for 1993-1998 lincoln mark viii (8)
페이지 인쇄
GENERAL INFORMATION:
Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement,
the full text of which is available at www.arnottinc.com.
•
Not to be stored below 5
•
Avoid damage to air lines and cables.
•
Removal and installation is only to be performed by fully qualified personnel.
•
Use car manufacturer's diagnostic software.
CAUTION: Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified
in the instructions or in a different sequence.
To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to
disconnect your battery.
Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for
additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath
the vehicle if it is not adequately supported, as serious injuries and death can occur.
AIR SUSPENSION COMPRESSOR REMOVAL
1.
Turn air suspension switch to the off position. (Switch is located on the right side of the trunk.)
2.
Locate compressor on the right side of the vehicle, behind the front bumper.
3.
To remove the front bumper cover, start with removing front side marker/cornering lamps.
4.
Remove the radiator upper sight shield (FIGURE A).
2
P-2210
ARNOTT AIR SUSPENSION COMPRESSOR
FOR
LINCOLN MARK VIII (8)
o
o
o
F (-15
C) or above 122
2210
P-
1993-1998
o
F (50
C).
FIGURE A
REV 3
04/16/2015