3D Global DTC133UHL 사용 설명서 - 페이지 12

{카테고리_이름} 3D Global DTC133UHL에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Global DTC133UHL 18 페이지.

• Not in the vicinity of easily inflammable materials

• On a stable flat surface of a suitable table with sufficient load-bearing capacity

and an ergonomically expedient working height (e.g. inspection workstation)

• No direct sunlight

Temperature range:

Relative humidity:

Altitude:

Atmospheric pressure

Voltage fluctuations:

Cleanliness level

of the environment:

3.5.2 Required additional devices / accessories

• Additional hardware (e.g. control PC, signal processing unit of a SCALEREO

microscope system, etc.) and special software (e.g. headtracking software, image

processing, image tracking, etc.) as well as optionally available accessories (e.g.

power supply, stand, ...) are required to operate the device as intended. All this is not

part of the product.

• The correct selection of suitable hardware and software as well as the accessories

used for use is the sole responsibility of the operator.

Any use outside the product limits and their conditions listed in paragraphs 3.2 -

3.5 as well as any modifications in or on the device are not permitted. The

declaration of conformity does not apply to devices used or modified in this way.

The manufacturer accepts no liability for any resulting risks

Manual_DTC133UHL_EN

10° - 40° C

max. 80% at temperatures up to 30° C

then linear decrease to 50% at 40°

max. 2.000 m above sea level

min. 800 hPa

max. 10% of nominal voltage

Cleanliness level SaS 1

(Clean zone according to VDA 19.2)

Rev. 1.0 / 17.11.2022

12 / 18