3D Hobby Shop 62 inch OSIRIS 조립 설명서 - 페이지 14

{카테고리_이름} 3D Hobby Shop 62 inch OSIRIS에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 62 inch OSIRIS 14 페이지.

Center of Gravity:

Allowable range 6.5 inches – 7.25 inches

Measuered from leading edge of wing at root, where the wing meets the fuselage.

Recommended CG for competition flight: 7.0 inches

Recommended components:

Motor Hacker A50-12S

ESC Castle ICE 100 or Phoenix HV-85

BEC Castle BEC pro or Castle BEC 10A

Aileron and elevator servo Hitec Hs-5245MG

Rudder servo Hitec 7985MG

APC 15x10E or 15x12E prop

Before flight:

Make sure wing screws are installed and secure.

Double check all ball-link screws and locknuts.

Make sure canopy latch is fully engaged.

Balance prop accurately.

A full selection of spare and repair parts for your Osiris is available at

www.3DHobbyShop.com

We hope you enjoy your 3D HOBBY SHOP Aircraft.

Be sure to look for new aircraft and products coming soon from

3 D H O B B Y S H O P . C OM