3D Hobby Shop 62 inch OSIRIS 조립 설명서 - 페이지 13

{카테고리_이름} 3D Hobby Shop 62 inch OSIRIS에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 62 inch OSIRIS 14 페이지.

Install servo as shown, assemble aileron pushrods as shown, use allen screws with locknuts
Mount receiver to receiver tray immediately in front of wing spar tube.
Use included Velcro selection to secure lipo battery to battery tray.
NOTE: Fly your initial flights on low rate. You may desire some exponential on high rate to
to attach ball links to servo arm and control horn.

SETUP NOTES:

Recommended control throws.
Elevator Low rate 12 degrees up and down
Mid rate 17 degrees up and down
High rate 22 degrees up and down
Aileron
Low rate 15 degrees up and down
Mid rate 20 degrees up and down
High rate 25 degrees up and down
Rudder Low rate 25 degrees right and left
Mid rate 30 degrees right and left
High rate 35 degrees right and left
tune the feel to your personal preference.
13