3D Hobby Shop 62 inch OSIRIS Посібник з монтажу - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшка 3D Hobby Shop 62 inch OSIRIS. 3D Hobby Shop 62 inch OSIRIS 14 сторінок.

Install servo as shown, assemble aileron pushrods as shown, use allen screws with locknuts

Mount receiver to receiver tray immediately in front of wing spar tube.

Use included Velcro selection to secure lipo battery to battery tray.

NOTE: Fly your initial flights on low rate. You may desire some exponential on high rate to

to attach ball links to servo arm and control horn.

SETUP NOTES:

Recommended control throws.

Elevator Low rate 12 degrees up and down

Mid rate 17 degrees up and down

High rate 22 degrees up and down

Aileron

Low rate 15 degrees up and down

Mid rate 20 degrees up and down

High rate 25 degrees up and down

Rudder Low rate 25 degrees right and left

Mid rate 30 degrees right and left

High rate 35 degrees right and left

tune the feel to your personal preference.