3D Hobby Shop 70 AJ SLICK 조립 설명서 - 페이지 12

{카테고리_이름} 3D Hobby Shop 70 AJ SLICK에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 70 AJ SLICK 19 페이지.

When stabilizer is centered and aligned, drip Thin CA glue onto the stab-to-fuselage joint

top and bottom. NOTE: We do not remove any covering form the horizontal stabilizer.

This keeps the stabilizer strong, and thin CA makes an excellent joint to covering material.

If your stab joint is not tight enough for thin CA glue, or if you have to trim the opening to

align the stab, you can use thick CA glue as well.

Hinge the elevators onto the horizontal stabilizer, starting with the elevator which has the

joiner attached. Use the same procedure as on the rudder. Make sure the elevator can

swing 45 degrees up and down, minimum.