3D Hobby Shop 70 AJ SLICK Посібник з монтажу - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшка 3D Hobby Shop 70 AJ SLICK. 3D Hobby Shop 70 AJ SLICK 19 сторінок.

Друкувати сторінку
12
When stabilizer is centered and aligned, drip Thin CA glue onto the stab-to-fuselage joint
top and bottom. NOTE: We do not remove any covering form the horizontal stabilizer.
This keeps the stabilizer strong, and thin CA makes an excellent joint to covering material.
If your stab joint is not tight enough for thin CA glue, or if you have to trim the opening to
align the stab, you can use thick CA glue as well.
Hinge the elevators onto the horizontal stabilizer, starting with the elevator which has the
joiner attached. Use the same procedure as on the rudder. Make sure the elevator can
swing 45 degrees up and down, minimum.