3D Hobby Shop 70 AJ SLICK 조립 설명서 - 페이지 15
{카테고리_이름} 3D Hobby Shop 70 AJ SLICK에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 70 AJ SLICK 19 페이지.
페이지 인쇄15
Cut small strips of paper or card stock and use masking tape to affix them to the fuselage as shown, to
indicate the exact location of the four cowl-mounting tabs which extend forward form the fuselage.
Install the cowl, and use the paper strips as guides to make holes in the cowl over the tabs. You can use
a twisting motion with your hobby knife to start these holes. Use a 1/16" or smaller drill bit to finish
making these holes. Install wood screws into these holes, and then remove. Remove the cowl and
screws and soak the plywood mounting tabs in thin CA glue. This will strengthen the mounting tabs. Re-
install the screws.