3D Hobby Shop 70 AJ SLICK Montaj Kılavuzu - Sayfa 15

Oyuncak 3D Hobby Shop 70 AJ SLICK için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. 3D Hobby Shop 70 AJ SLICK 19 sayfaları.

Cut small strips of paper or card stock and use masking tape to affix them to the fuselage as shown, to

indicate the exact location of the four cowl-mounting tabs which extend forward form the fuselage.

Install the cowl, and use the paper strips as guides to make holes in the cowl over the tabs. You can use

a twisting motion with your hobby knife to start these holes. Use a 1/16" or smaller drill bit to finish

making these holes. Install wood screws into these holes, and then remove. Remove the cowl and

screws and soak the plywood mounting tabs in thin CA glue. This will strengthen the mounting tabs. Re-

install the screws.