3D Hobby Shop 70 AJ SLICK 조립 설명서 - 페이지 6

{카테고리_이름} 3D Hobby Shop 70 AJ SLICK에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 70 AJ SLICK 19 페이지.

Remove the hinges from the tail surfaces. Use a q-tip to apply Vaseline to the center area of the hinge.

We do this to keep glue out of the rotating part of the hinge. We use Vaseline, instead of oil, so that we

can contain the Vaseline to only the center part of the hinge. We need the ends of the hinges to remain

dry and clean so that the glue will bond them securely.

Place several drops of either polyurethane glue (gorilla glue – honey-colored) or epoxy (30 minute is

preferred) into the hinge holes on both the vertical stab and rudder. Wipe away any excess which drips

out with rubbing alcohol on a paper towel. Insert the rudder hinges into the holes in the stab, making sure

they are aligned correctly so that the rudder can swing back and forth.