3D Hobby Shop 70 AJ SLICK 조립 설명서 - 페이지 7
{카테고리_이름} 3D Hobby Shop 70 AJ SLICK에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 70 AJ SLICK 19 페이지.
페이지 인쇄7
Insert the rudder onto the hinges and tail-wheel tiller wire as shown. Swing the rudder back and forth
several times to make sure it swings easily 45 degrees each way. Clean any glue which seeps out of the
hinges and allow to dry. If using polyurethane glue, you may see more glue seeping out as it dries. Wipe
this away with alcohol. Allow to dry.
Note about rudder servo: For virtually all setups, you will use a pull-pull cable rudder system.
The following instructions describe this. If you install a very heavy power system, however, you
can use a push-pull rudder system. Photos are included at the end of the manual.
Remove covering over the rudder control arms slots, as shown, on both sides of the rudder.